Pioneer KRP-600A - Manual (Page 46)

Setting up 08
46
En
Note
• When you change the Energy Save mode, you may notice a
change in the panel sound. This is normal.
• The Energy Save function can maintain efficiency of the screen
for a long period of time. Setting the Energy Save function to
“Mode1” is recommended in order to maintain the efficiency of
the screen for a long period of time.
No Signal off (AV source only)
The system will be automatically placed into the standby mode if no
signal is received for 15 minutes.
1 Repeat steps 1 to 3 provided for Energy Save.
2 Select “No Signal off” ( / then ENTER).
3 Select “Enable” ( / then ENTER).
4 Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby mode,
a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the Media Receiver after a TV
programme finishes.
No Operation off (AV source only)
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1 Repeat steps 1 to 3 provided for Energy Save.
2 Select “No Operation off” ( / then ENTER).
3 Select “Enable” ( / then ENTER).
4 Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby mode,
a message appears every minute.
Power Management (PC source only)
The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1 Repeat steps 1 to 3 provided for Energy Save.
2 Select “Power Management” ( / then ENTER).
3 Select “Mode1” or “Mode2” ( / then ENTER).
4 Press HOME MENU to exit the menu.
Note
• This function is not selectable when the PC is connected to the
HDMI terminal.
Picture Off
To save energy and extend the life of your display, have the screen
turn Off. To deactivate the screen, follow the steps below.
1 Press TOOLS.
The TOOLS Menu appears on screen.
2 Select “Picture Off” from the TOOLS Menu.
3 Press ENTER.
The screen display turns Off.
To restore the screen display, press any buttons other than
i+/
i– and e.
Note
• The Picture Off setting is not memorized by the system.
No Signal off
Selections Disable
(default) Does not place the system into the
standby mode
Enable Places the system into the standby
mode if no signal is received for 15
minutes
No Operation off
Selections Disable
(default) Does not place the system into the
standby mode
Enable Places the system into the standby
mode if no operation is performed
for three hours
Item Description
Off (default) No power management
Mode1 • Places the system into the standby mode when
no signal is received from the personal computer
for eight minutes.
• Even when you start using the computer and a
signal is received again, the system stays off.
• The system is switched on again by pressing
STANDBY/ON on the Media Receiver or a on
the remote control unit.
Mode2 • Places the system into the standby mode when
no signal is received from the personal computer
for eight seconds.
• When you start using the computer and a signal
is input again, the system is switched on.
• The system is switched on again by pressing
STANDBY/ON on the Media Receiver or a on
the remote control unit.
KRP-600A_500A.book Page 46 Monday, September 8, 2008 10:31 AM