Operating range of the remote control unit, Preparation 05 – Pioneer KRP-600A User Manual

Page 23

Advertising
background image

Preparation

05

23

En

E

n

glish

Operating range of the remote control
unit

Operate the remote control unit while pointing it toward the remote
control sensor located at the bottom right of the front panel of the
display. The distance from the remote control sensor must be within
7 m and the angle relative to the sensor must be within 30 degrees
in the right, left, upward, or downward direction.

Note

• For remote control sensor locations, see Part names on page 12.

Caution

• Do not expose the remote control unit to shock. In addition, do

not expose the remote control unit to liquids, and do not place
in an area with high humidity.

• Do not install or place the remote control unit under direct

sunlight. The heat may cause deformation of the unit.

• The remote control unit may not work properly if the remote

control sensor of the display is under direct sunlight or strong
lighting. In such case, change the angle of the lighting or
display, or operate the remote control unit closer to the remote
control sensor.

• When any obstacle exists between the remote control unit and the

remote control sensor, the remote control unit may not function.

• As the batteries become empty, the remote control unit can

function within a shorter distance from the remote control
sensor. Replace the batteries with new ones early enough.

• The display emits very weak infrared rays from its screen. If you

place such equipment operated through infrared remote
control as a VCR nearby, that equipment may not receive
commands from its remote control unit properly or entirely. If
this is the case, place that equipment at a location far enough
from the flat screen TV.

• Depending on the installation environment, infrared rays from

the display may not allow this system to properly receive
commands from the remote control unit or may shorten
allowable distances between the remote control unit and the
remote control sensor. The strength of infrared rays emitted
from the screen differs, depending on images displayed on the
screen.

30º

30º

7 m

Remote
control
sensor

KRP-600A_500A.book Page 23 Monday, September 8, 2008 10:31 AM

Advertising
This manual is related to the following products: