Pioneer KRP-600A - Manual (Page 18)

Preparation 05
18
En
Attach the colour sensor to the rear panel
Methods of attaching the colour sensor to the rear panel differ
depending on the panel with or without side-mounted speakers.
(when side-mounted speakers are installed)
1
Remove the screws of the colour sensor then replace the
bracket.
Use the removed screws again.
2 Loosen the upper two (2) speaker bracket screws.
3 Fit the colour sensor bracket’s lower grooves into the screws.
Adjust the colour sensor/speaker bracket positions so as to stay in
place.
4 Fasten the screws.
5 Connect the cable to the colour sensor terminal on the rear
upper bank but do NOT plug in to the power outlet.
Note
• Do not loosen the screws at the bottom of the panel. When attached to the rear panel, the sensor window points upward.
• If the colour sensor attached to the rear panel does not operate properly, attach it to the front panel.
• Do not use the supplied screws when attaching the colour sensor using the speaker brackets.
• The colour sensor may become hot due to a heat emitted from the panel. When using it in a high-temperature environment, attach the
colour sensor to the bottom of the front panel.
(when side-mounted speakers are not installed)
1 Remove the screws of the colour sensor then replace the
bracket.
Use the removed screws again.
2
Finger tighten the supplied colour sensor screws in the
speaker screw holes.
3
Fit the colour sensor bracket’s lower grooves into the screws.
Adjust the bracket position to stay in place.
4
Fasten the screws.
5 Connect the cable to the colour sensor terminal on the rear
upper bank but do NOT plug in to the power outlet.
(Bracket)
Colour sensor cable Cable clamp
Colour sensor terminal
(upper bank)
Cable clamp
Colour sensor
Speaker cable Cable guide
(supplied with the
colour sensor)
Cable guide (supplied
with the flat screen TV)
(KRP-600P)
Colour sensor terminal
(upper bank)
Colour sensor cable
Cable clamp
(KRP-500P)
KRP-600A_500A.book Page 18 Monday, September 8, 2008 10:31 AM