Mp3 file playback, Mpeg-4 aac file playback, Cautions on use – Pioneer PD-10-K User Manual

Page 13: Moving the player, Place of installation, Turn the power off when not using the player, Condensation, Cleaning the player, Cleaning the pickup lens, Handling discs

Advertising
background image

Additional information

06

13

En

English

Deutsch

Français

Nederlands

Italiano

Español

Ру

сский

MP3 file playback

• Please use discs recorded to compatibility with CD-

ROM file systems (ISO9660 level 1 and 2), and those

compatible with extended format (Joliet, Romeo).

• This unit does not support Variable Bit Rate (VBR);

(even if files are playable, the times shown in the

front panel display will be incorrect due to the

change in bitrate, thus changing faster or slower

than the correct time values.)

• This unit does not support multi-session discs.
• A total maximum of 648 folders and tracks can be

recognized and played. Of that number, a

maximum of 299 may be folders. However,

depending on the folder composition, not all folders

and tracks can be recognized and played.

• For optimum sound quality, bit rates of 128 kbps or

higher are recommended for recordings.

MPEG-4 AAC file playback

• AAC is an acronym for “Advanced Audio Coding,”

the basic format for audio compression technology

used in MPEG-2 and MPEG-4.

• This unit supports the playback of AAC files with

the extension “.m4a,” as encoded by iTunes®.

However, playback may not be possible in the case

of files copy protected by DRM, and depending on

the iTunes encoding version.

• iTunes is a trademark of Apple Inc., registered in

the U.S. and other countries.

Cautions on use

Moving the player

When moving this unit to a new location, always perform

the following procedure first: Remove any disc loaded

and close the disc tray. Press the unit’s /I STANDBY/
ON

button so that the [-OFF-] appears in the front panel

display, then wait ten seconds before disconnecting the

power cord. Damage or malfunctions may result if the

unit is moved with a disc loaded in the tray.

Place of installation

Select a stable place near the TV and AV system to which

the unit is connected.
Do not place the player on top of a TV or color monitor.

Keep it away from cassette decks or other components

easily affected by magnetism.
Avoid the following types of places:

• Places exposed to direct sunlight

• Humid or poorly ventilated places
• Extremely hot or cold places
• Places subject to vibration
• Places in which there is much dust or cigarette

smoke

• Places exposed to soot, steam or heat (in kitchens,

etc.)

Do not mount the unit on a sofa or other object or

material with absorbent qualities, since sound quality

may be adversely affected.

Do not place objects on top

Do not place objects on top of the player.

Keep away from heat

Do not place the player on top of an amplifier or other

device generating heat. When installing in a rack, to

avoid the heat generated by the amplifier and other

devices, place it on a shelf below the amplifier whenever

possible.

Turn the power off when not using the
player

Depending on the conditions of the TV broadcast

signals, striped patterns may appear on the screen when

the TV is turned on while the player’s power is turned on.

This is not a malfunction with the player or TV. If this

happens, turn the player’s power off. In the same way,

noise may be heard in the sound of a radio.

Condensation

If the player is moved suddenly from a cold place into a

warm room (in winter, for example) or if the temperature

in the room in which the player is installed rises

suddenly due to a heater, etc., water droplets

(condensation) may form inside (on operating parts and

the lens). When condensation is present, the player will

not operate properly and playback is not possible. Let the

player stand at room temperature for 1 or 2 hours with

the power turned on (the time depends on the extent of

condensation). The water droplets will dissipate and

playback will become possible.
Condensation can also occur in the summer if the player

is exposed to the direct wind from an air-conditioner. If

this happens, move the player to a different place.

Cleaning the player

Normally, wipe the player with a soft cloth. For tough dirt,

apply some neutral detergent diluted in 5 to 6 parts water

to a soft cloth, wring out thoroughly, wipe off the dirt,

then wipe again with a dry cloth.

Note that getting alcohol, thinner, benzene or

insecticide on the player could cause the print and

coating to peel off. Also, avoid leaving rubber or vinyl

products in contact with the player for long periods of

time, as this could damage the cabinet.
When using chemical-impregnated wipes, etc., read the

wipe’s cautions carefully.
Unplug the power cord from the power outlet when

cleaning the player.

Caution for when the unit is installed in a
rack with a glass door

Do not press the  OPEN/CLOSE on the remote control

to open the disc tray while the glass door is closed. The

door will hamper the movement of the disc tray, and the

unit could be damaged.

Cleaning the pickup lens

The player’s lens should not become dirty in normal use,

but if for some reason it should malfunction due to dust

or dirt, consult your nearest Pioneer authorized service

center. Although lens cleaners for players are

commercially available, we advise against using them

since some may damage the lens.

Handling discs

Do not use damaged (cracked or warped) discs.
Do not scratch the disc’s signal surface or let it get dirty.
Do not load more than one disc into the player at a time.
Do not glue paper or put stickers onto the disc, or use a

pencil, ball-point pen or other sharp-tipped writing

instrument. These could all damage the disc.

Storing discs

Always store discs in their cases, and place the cases

vertically, avoiding places exposed to high temperatures

or humidity, direct sunlight or extremely low

temperatures.
Be sure to read the cautions included with the disc.

Cleaning discs

It may not be possible to play the disc if there are

fingerprints or dust on it. In this case, using a cleaning

cloth, etc., to wipe the disc gently from the center toward

the outer edge. Do not use a dirty cleaning cloth.

Do not use benzene, thinner or other volatile chemicals.

Also do not use record spray or antistatic agents.
For tough dirt, apply some water to a soft cloth, wring out

thoroughly, wipe off the dirt, then wipe off the moisture

with a dry cloth.

Specially shaped discs

Specially shaped discs (heart-shaped, hexagonal, etc.)

cannot be used on this player. Never use such discs, as

they will damage the player.

Condensation on discs

If the disc is moved suddenly from a cold place into a

warm room (in winter, for example), water droplets

(condensation) may form on the disc surface. Discs will

not play properly if there is condensation on them.

Carefully wipe off the water droplets from the disc

surface before using the disc.

PD-30_PWSYXZT8.book 13 ページ 2012年5月7日 月曜日 午前11時33分

Advertising
This manual is related to the following products: