Before you start, Disc/content format playback compatibility, About dualdisc playback – Pioneer PD-10-K User Manual

Page 4: Discs that cannot be played, What’s in the box, Loading the batteries in the remote control, Using the remote control

Advertising
background image

Before you start

01

4

En

Chapter 1:

Before you start

Disc/content format playback
compatibility

Discs playable on this player are as shown below.

• SACD (Super Audio CD)*

(2-channel area only)

• CD
• DSD disc

* “Super Audio CD” is a registered trademark.

Note

• This unit does not permit playback of the multi-

channel areas of SACD discs.

• This unit’s DIGITAL OUT terminals do not output

sound from SACD and DSD discs, nor from iPod/

iPhone/iPad devices.

• When a disc is loaded, turning on the power will not

cause playback to automatically start. As a result,

timed playback is not possible even if the unit is

connected to a timer.

About DualDisc playback

A DualDisc is a new two-sided disc, one side of which

contains DVD content video, audio, etc. while the other

side contains non-DVD content such as digital audio

material. The non-DVD, audio side of the disc is not

compliant with the CD Audio specification and therefore

may not play. For more detailed information on the

DualDisc specification, please refer to the disc

manufacturer or disc retailer.

Discs that cannot be played

• DVD-Video
• DVD-Audio
• CD-G
• Video CD
• DTS CD

It is possible that some discs other than the ones listed

above may not be playable either.

What’s in the box

Please confirm that the following accessories are in the

box when you open it.

• Remote control x1
• AAA/IEC R03 dry cell batteries x2
• RCA audio cable (red/white plugs) x1
• Power cord
• Warranty card
• Operating instructions (This document)

Note

• Illustrations featured in the Operating Instructions

may have been modified or simplified for ease of

explanation, and may therefore differ from the

actual product appearance.

• The illustrations used here are mainly of the PD-30.

Loading the batteries in the remote
control

1

Open the rear lid.

PD-30

PD-10

2

Insert the new batteries, matching the

polarities as indicated inside the case.

3

Close the rear lid.

The batteries included with the unit have been provided

to allow you check product operation and may not last

long. We recommend using alkaline batteries that have

a longer life.

WARNING

• Do not use or store batteries in direct sunlight or

other excessively hot place, such as inside a car or

near a heater. This can cause batteries to leak,

overheat, explode or catch fire. It can also reduce

the life or performance of batteries.

Caution

Incorrect use of batteries may result in such hazards as

leakage and bursting. Observe the following

precautions:

• When inserting the batteries, make sure not to

damage the springs on the battery’s  terminals.

• Do not use any batteries other than the ones

specified. Also, do not use a new battery together

with an old one.

• When loading the batteries into the remote control,

set them in the proper direction, as indicated by the

polarity marks ( and ).

• Do not heat batteries, disassemble them, or throw

them into flames or water.

• Batteries may have different voltages, even if they

are the same size and shape. Do not use different

types of batteries together.

• To prevent leakage of battery fluid, remove the

batteries if you do not plan to use the remote

control for a long period of time (1 month or more).

If the fluid should leak, wipe it carefully off the

inside of the case, then insert new batteries. If a

battery should leak and the fluid should get on your

skin, flush it off with large quantities of water.

• When disposing of used batteries, please comply

with governmental regulations or environmental

public institution’s rules that apply in your country/

area.

Using the remote control

The remote has a range of about 7 m at an angle of about

30º from the remote sensor.

Keep in mind the following when using the remote

control:

• Make sure that there are no obstacles between the

remote and the remote sensor on the unit.

• Remote operation may become unreliable if strong

sunlight or fluorescent light is shining on the unit’s

remote sensor.

• Remote controllers for different devices can

interfere with each other. Avoid using remotes for

other equipment located close to this unit.

• Replace the batteries when you notice a fall off in

the operating range of the remote.

PD-30

PD-10

PD-30

PD-10

7 m

30 °

30 °

PD-30_PWSYXZT8.book 4 ページ 2012年5月7日 月曜日 午前11時33分

Advertising
This manual is related to the following products: