Baracoda All in One Printer - Manual (Page 38)

ToughRunners / ScanWear – Communication Protocol v1.2 - 38 -
Data Capture
for Workforce
in Motion
6. Appendix B: Decoder Protocol.
This section describes in detail the 20 bytes of the response/payload of the 0x80/0x81.
Byte # Byte name Default value
1 COD1 0xB4
2 COD2 0x90
3 OPC39 0xEF
4 OPMUL 0x20
5 OP25I 0x36
6 LEI1 0x00
7 LEI2 0x00
8 LEI3 0x00
9 OP25S 0x77
10 LES1 0x00
11 LES2 0x00
12 LES3 0x00
13 OPMON 0xE3
14 OPEAN1 0x2F
15 OPEAN2 0x08
16 OPC93 0x00
17 FNC1 0x1D
18 RSS 14 (GSS Databar) 0x3B
19 RSS Ltd (GSS Databar Ltd) 0x3B
20 RSS Expanded (GSS Databar Expanded) 0x3B
The symbologies 18,19,20 are available since firmware version 3.02.03.
COD1 Description Default
b0 Reserved 0
b1 Enable MSI-PLESSEY 0
b2 Enable Code 128 1
b3 Enable standard 2/5 0
b4 Enable CODABAR / MONARCH 1
b5 Enable UPC/EAN 1
b6 Enable interleaved 2/5 0
b7 Enable CODE 39 1
COD2 Description Default
b0 unused 0
b1 unused 0
b2 unused 0
b3 unused 0
b4 Enable EAN 128 1
b5 Enable AIM ID for EAN128 0
b6 Disable EAN8 check digit transmission 0
b7 Enable code 93 1
Remark:
The EAN128 is encoded with code128 symbology.
When code128 is enabled, EAN128 barcodes are decoded but the symbology ID is the
code128’s one.