Baracoda All in One Printer - Manual (Page 5)

ToughRunners / ScanWear – Communication Protocol v1.2 - 5 -
Data Capture
for Workforce
in Motion
2. Command ID summary
The commands are sorted by category (4 MSB of Command ID):
0x0? Scanner control commands
0x01 Enter "Setting Mode"
0x02 Exit "Setting Mode"
0x03 Launch autotest // RESERVED
0x04 Endurance (AutoScan) test setting // RESERVED
0x05 Retrieve operational statistics
0x06 Reset operational statistics
0x07 Get wrist motion detection level
0x08 Set wrist motion detection level
0x0E firmware presence flag // RESERVED
0x0F Restore default settings
0x1? RESERVED
0x2? Firmware upgrade commands // RESERVED
0x27 Start programming (application AT89C51ED2)
0x28 End programming
0x29 Clear firmware
0x2A Read 128Byte bloc
0x2B Write 128Byte bloc
0x2C Verify checksum
0x2D Read Boot cartouche
0x2E Read Application cartouche
0x2F Switch to download mode