Pioneer LX01BD User Manual
Page 14
02
14
En
-
5
Connect the Blu-ray disc player to the receiver subwoofer.
a. Plug the control cable into the
CONTROL OUT 1 jack on the side
of the receiver subwoofer.
Plug the other end of the cable into the
CONTROL IN jack on the
rear of the Blu-ray disc player.
b. Plug the HDMI cable into the
HDMI IN 1 jack on the rear of the
receiver subwoofer.
Plug the other end of the cable into the
HDMI OUT jack on the
rear of the Blu-ray disc player.
6
Connect the receiver subwoofer to your TV.
• Connect the
HDMI OUT jack on receiver subwoofer to an HDMI
input on your TV.
• You can have audio from the receiver subwoofer, as well as
audio and video from the Blu-ray disc player, output to your TV
by connecting with a single HDMI cable.
7
Connect an audio cable from your TV to the receiver
subwoofer.
• To listen to TV audio on this unit, connect the TV’s audio output
to
DIGITAL OPTICAL IN 1 on the receiver subwoofer.
To use the HDMI Control function when you are connected to a
supported Pioneer Flat Screen TV, you must connect via HDMI.
• You must first set ‘
TV Input’ to switch the audio from a Flat
Screen TV with the HDMI Control function or to switch the input
source of this unit to TV audio and operate your TV with the
supplied remote control. For more information, see Operating
Pioneer Flat Screen TV and TVs on page 21 and Audio input
settings from TVs (TV Input) on page 40.
R
R
AUDIO OUT ( 2 ch )
AUDIO OUT ( 7.1 ch )
VIDEO OUT
HDMI OUT
DIGITAL
OUT
CONTROL
IN
L
L
Y
PB
PR
FRONT
OPTICAL
COMPONENT
VIDEO
SURROUND
CENTER
VIDEO
S-VIDEO
SUB WOOFER
SURROUND BACK
AC IN
HDMI
OUT
IN 3
SYSTEM
IN 2
IN 1
OPTICAL
IN
1
IN
2
OUT
1
OUT
2
DIGITAL
CONTROL
6
7
5
TV
From digital audio
output (optical)
To HDMI input
Rear panel
Side panel
Receiver subwoofer
Blu-ray disc player
Note that unless the control cable is connected, you can’t use
the remote control with the Blu-ray disc player.
LX01BD_1.book Page 14 Tuesday, September 2, 2008 12:33 PM