Pioneer LX01BD - Manual (Page 53)

53
En
10
Tuner
HDMI
Displayed Messages
Problem Remedy
Considerable noise in radio
broadcasts. • Connect the AM antenna (refer to Connecting up on page 10) and adjust the direction and position for best
reception. You may also connect an additional internal or external AM antenna (refer to Connecting external
antennas on page 42).
• Fully extend the FM wire antenna, position for best reception, and secure to a wall. You may also connect an
outdoor FM antenna (see Connecting external antennas on page 42).
• Turn off other equipment that may be causing the noise or move it further away.
Auto tuning does not pick up some
stations. • The radio signal is weak. Auto tuning will only detect radio stations with a good signal. For more sensitive
tuning, connect an outdoor antenna.
Symptom Remedy
No picture or sound. • This receiver is HDCP-compatible. Check that the components you are connecting are also HDCP-
compatible.
• Depending on the connected source component, it’s possible that it will not work with this receiver (even if
it is HDCP-compatible).
• If the problem still persists when connecting your HDMI component directly to your monitor, please consult
the component or monitor manual or contact the manufacturer for support.
No sound, or sound suddenly
ceases. • Check that the HDMI Mode setting is set to AMP Mode/Through Mode.
• If the component is a DVI device, use a separate connection for the audio.
• Check the audio output settings of the source component.
HDMI Control does not function. • Verify that the HDMI cable is firmly connected.
• Make sure that this unit’s HDMI Control mode is set to
Control On (page 46).
• Check whether the connected component supports HDMI Control or not. For more information refer to the
operating instructions of your Flat Screen TV, HDD/DVD recorder, DVD player, etc.
• This unit does not guarantee HDMI Control-compatible components other than those made by Pioneer.
Message Description
192kHz PCM
SACD
DTS-HD
DTS Express
Dolby TrueHD
Dolby D+ These messages are displayed when you operate a function incompatible with the audio source being played
back.
No MIC Displays when you press MCACC when the MCACC setup mic is not connected.
Muting Displays when you press TEST TONE or MCACC while this unit is muted.
2ch Only An operation is prohibited because it is only applicable to 2 channel sources, while the current source is a
multichannel source.
Exit Appears when a menu is automatically exited after a set period of inactivity.
HDMI Through Displays when you change the Listening Mode, the volume level, or some sound settings when the HDMI
Mode is set to Through Mode.
Unknown The genre information for contents being played back on a Pioneer HDD/DVD recorder cannot be obtained.
No Genre There is no genre set for contents being played back on a Pioneer HDD/DVD recorder.
HDMI C.ERR 2C* The connected component is not compatible with synchronized genre mode.
Can’t use • You tried to use Genre Sync Mode for a source component that does not support this function.
• The source component is in a situation where Genre Sync Mode cannot be used.
• You tried to use Genre Sync Mode when the input source of this unit is a source other than HDMI.
• The operation is forbidden due to the surround settings.
• When the volume level is over 51, some functions are restricted.
LX01BD_1.book Page 53 Tuesday, September 2, 2008 12:33 PM