Pioneer LX01BD - Manual (Page 54)

10
54
En
Specifications
 Audio Multi-channel Receiver Subwoofer
HDMI C.ERR 1** Check if the HDMI cable is properly connected. If the cable is properly connected, this unit may be damaged.
In such an event, please contact a Pioneer-authorized service center or your nearest dealer.
Noisy! Background noise is too high to complete MCACC setup successfully.
Error MIC! An error occurred during MCACC setup because the microphone is not connected or is not connected properly.
Error Speaker! An error occurred during MCACC setup because the speakers are not connected or are not connected properly.
Over Temp Try lowering the volume. If this problem is not fixed by removing and inserting the power cable, this unit may
be damaged. In such an event, please contact a Pioneer-authorized service center or your nearest dealer.
OC Error1
OC Error2 Check whether the speaker cables are short-circuited. If the error message continues to be displayed, contact
your Pioneer authorized service center or your dealer for servicing.
*** BackUpERR Contact your Pioneer authorized service center or your dealer for servicing.
Message Description
Model SX-LX70SW
Rated voltage AC 220 V to 240 V
Rated frequency 50 Hz/60 Hz
Power consumption 69 W
Power consumption (standby) 0.39 W (HDMI Control ON)
0.29 W (HDMI Control OFF)
Weight 17.8 kg
External dimensions (including projecting parts) 245 mm (W) x 409 mm (H) x 600 mm (D)
Tolerable operating temperature +5 °C to +35 °C
Tolerable operating humidity 5 % to 85 % (no condensation)
Amplifier section:
RMS Power Output
(8 channel output) Front, Center, Surround (6 channel) 50 W per channel (1 kHz, 10 % T.H.D., 8
Ω)
Dual Subwoofer (2 channel) 100 W (50 W+ 50 W) (100 Hz, 10 % T.H.D., 8 Ω)
FM tuner section Frequency range 87.5 MHz to 108 MHz
Antenna 75 Ω, unbalanced
AM tuner section Frequency range 531 kHz to 1602 kHz
Antenna Loop antenna
Subwoofer section Enclosure Bass-reflex floor type (magnetically shielded)
System 18 cm 1-way system
Speaker 18 cm cone type x2
Nominal impedance 8 Ω
Frequency range 30 Hz to 500 Hz
Maximum Input Power 50 W x2
Input/Output section
HDMI terminal Input 19 pin x3
Output 19 pin (5 V, 100 mA)
Other connector System connector 26 pin
Audio input Optical x2 (Digital)
RCA (2 pin) (Analog)
Control output Mini jack x2
Display unit System connector 26 pin
Front Audio input Mini jack
MCACC input Mini jack
iPod input 20 pin (12 V, 420 mA)
LX01BD_1.book Page 54 Tuesday, September 2, 2008 12:33 PM