Pioneer VSX-D510 - Manual (Page 28)

28
En
08
Making a Recording
Making an Audio or a Video
Recording
The following steps show you how to make an audio or
a video recording from the built in tuner, or from an
audio or video source connected to the receiver (such as
a CD player or TV). Recordings can be made to a CD-
Recorder, cassette deck, MD, VCR, or DVR deck
connected to the CD-R/TAPE/MD, VCR or DVR in/out
connectors.
MEMO:
The receiver's volume, balance, tone (bass, treble,
loudness), and surround effects have no effect on the
recorded signal.
1
MONITOR
1 Turn the MULTIJOG DIAL on the receiver or
press the FUNCTION button on the remote
control to select a source to record (you can
also use the
MULTI CONTROL buttons on the
remote control to select a source).
All functions except MONITOR are accessible from
the remote control.
2 Prepare the program source.
Tune to the radio station, load the CD, etc. For a
video recording load the video, DVD etc.
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS CHANNEL
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
1 ¡ 4 ¢
7 8 3
SOURCE CLASS MPX BAND
1
3 Insert a blank tape, MD, video etc. into the
recording device connected to either CD-R/
MD/TAPE or VCR/DVR and set the recording
levels.
Refer to the instructions that came with the recorder
if you are unsure how to do this. Most video
recorders set the audio recording level
automatically—check your video's instruction
manual if you are unsure whether yours has manual
controls.
4 Start recording, then start playback of the
source component.
Record MONITOR
You can listen to (monitor) the recording as it's being
made using the
MONITOR button on the front panel (a
cassette deck would have to have a record monitor
function).
Press the
MONITOR button to switch between the
recorded signal and the original source signal.