Pioneer VSX-D510 - Manual (Page 6)

6
En
03
Digital Audio Cords/Optical Cables
Commercially available digital audio coaxial cords
(standard video cords can also be used) or optical cables
(not supplied) are used to connect digital components to
this receiver.
When you use optical digital input or output terminals,
pull off the caps and insert the plugs. Be sure to insert
completely.
Digital audio coaxial cord
(or standard video cord) Optical cable
Connecting Your Equipment
Connecting Digital Components
In order to use PCM/2 Digital/DTS soundtracks, you need to make digital audio connections. You can do
this by either coaxial or optical connections (you do not need to do both). The quality of these two types of
connections is the same but since some digital components only have one type of digital terminal, it is a matter of
matching like with like (for example, the coaxial out from the component to coaxial in on the receiver). The VSX-
D510 has a coaxial and an optical input for a total of two digital inputs. Connect your digital components as shown
below.
When connecting your equipment, always make sure the power is turned off and the power cord is disconnected
from the wall outlet.
Audio/Video Cords
Use audio/video cords (not supplied) to connect the
video components and a video cord to connect the
monitor TV.
Connect red plugs to
R (right), white plugs to L (left),
and the yellow plugs to VIDEO .
Be sure to insert completely.
L
R
VIDEO
L R
L R
R L
CENTER
SPEAKER
FRONT
SPEAKERS TO
MONTOR
TV
VCR /
DVR
CONTROL
CD IN
IN IN OUT
OUT
FRONT
CD - R
/ TAPE
/ MD
SURROUND
CENTER
SUB
WOOFER
SUB
WOOFER
PREOUT
IN
IN
IN
IN
IN
TV /
SAT
DVD
/ LD
COAX OPT
(DVD) (CD)
P
L
A
Y
OUT
FM
UNBAL
75 Ω
AM LOOP
ANTENNA
FM
ANTENNA
DVD 5.1 CH
INPUT
PCM / 2 / DTS
DIGITAL IN
ASSIGNABLE
DIGITAL OUT
DIGITAL
OUT
COAX
DVD player
CD player
The arrows indicate the
direction of the audio signal.
Before making or changing the connections, switch off the power and disconnect the power cord from the AC
outlet.