Pioneer VSX-D510 - Manual (Page 7)

7
En
L R
L R
R L
CENT
SPEAK
FRONT
SPEAKERS TO
MONTOR
TV
VCR /
DVR
CONTROL
CD IN
IN IN OUT
OUT
FRONT
CD - R
/ TAPE
/ MD
SURROUND
CENTER
SUB
WOOFER
SUB
WOOFER
PREOUT
IN
IN
IN
IN
IN
TV /
SAT
DVD
/ LD
COAX OPT
(DVD) (CD)
P
L
A
Y
OUT
FM
UNBAL
75 Ω
AM LOOP
ANTENNA
FM
ANTENNA
DVD 5.1 CH
INPUT
PCM / 2 / DTS
DIGITAL IN
ASSIGNABLE
REC PLAY
L
R
L
R
OUTPUT
Connecting Audio Components
To begin set up, connect your audio components to the jacks as shown below. These are all analog connections and
your analog audio components (like a cassette deck) use these jacks. Remember that for components you want to
record with, you need to hook up four plugs (a set of stereo ins and a set of stereo outs), but for components that
only play, you only need to hook up one set of stereo plugs (two plugs). To use Digital source features you must hook
up your digital components to the digital inputs but it is also a good idea to hook up your digital components to
analog audio jacks. If you want to record to/from digital components (like an MD) to/from analog components, you
must hook up your digital equipment with these analog connections. See p.6 for more on digital connections.
When connecting your equipment, always make sure the power is turned off and the power cord is disconnected
from the wall outlet.
CD player
CD recorder
or Cassette deck
The arrows indicate the direction of the audio signal.
L R
L R
R L
FRONT
SPEAKERS TO
MONTOR
TV
VCR /
DVR
CONTROL
CD IN
IN IN OUT
OUT
FRONT
CD - R
/ TAPE
/ MD
SURROUND
CENTER
SUB
WOOFER
SUB
WOOFER
PREOUT
IN
IN
IN
IN
IN
TV /
SAT
DVD
/ LD
COAX OPT
(DVD) (CD)
P
L
A
Y
OUT
FM
UNBAL
75 Ω
AM LOOP
ANTENNA
FM
ANTENNA
DVD 5.1 CH
INPUT
PCM / 2 / DTS
DIGITAL IN
ASSIGNABLE
CENTER
SUB
WOOFER
VIDEO
OUT
SURROUND
OUTPUT
L
R
FRONT
OUTPUT
L
R
DVD/multi channel
decoder with 5.1 channel
analog output jacks
Connecting DVD 5.1 Channel Components
DVD and LD discs are compatible with both 2 channel and 5.1 channel audio output formats. Connections can be
made from a DVD, multi-channel decoder equipped with 5.1 analog outputs to the 5.1 analog inputs on this unit.
Always make sure that the receiver is switched off and unplugged from the wall outlet before making or changing any
connections.
Cassette deck placement
Depending on where the cassette deck is placed, noise may occur during playback of your cassette deck which is
caused by leakage flux from the transformer in the receiver. If you experience noise, move the cassette deck farther
away from the receiver.
MEMO:
• The 5.1 channel input can only be used when DVD 5.1 CH is selected.
Connecting Your Equipment