Brocade Communications Systems Brocade ICX 6650 - Manual (Page 115)

Brocade ICX 6650 Administration Guide 97
53-1002600-01
Viewing information about PoD licenses
4
A port is in a down state when there is no physical link between two devices, and a license is
installed in the device. The show interface ethernet command displays the port in the down
state. The following example output is from a Brocade ICX 6650 device.
A port is in an up state when a physical link is established between two devices, and a license
is installed in the device. The show interface ethernet command displays the port in the up
state. The following example output is from a Brocade ICX 6650 device.
Brocade# show interface ethernet 1/1/33
10GigabitEthernet1/1/33 is ERR-DISABLED (invalid license), line protocol is
down
Hardware is 10GigabitEthernet, address is 748e.f80c.5f40(bia 748e.f80c.5f40)
Interface type is unknown
Configured speed 10Gbit, actual unknown, configured duplex fdx, actual
unknown
Member of L2 VLAN ID 1, port is untagged, port state is DISABLED
BPDU guard is Disabled, ROOT protect is Disabled
Link Error Dampening is Disabled
STP configured to ON, priority is level0, mac-learning is enabled
Flow Control is enabled
Mirror disabled, Monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
Brocade# show interface ethernet 1/1/33
10GigabitEthernet1/1/33 is down, line protocol is down
Hardware is 10GigabitEthernet, address is 748e.f80c.5f40(bia 748e.f80c.5f40)
Interface type is unknown
Configured speed 10Gbit, actual unknown, configured duplex fdx, actual
unknown
Member of L2 VLAN ID 1, port is untagged, port state is BLOCKING
BPDU guard is Disabled, ROOT protect is Disabled
Link Error Dampening is Disabled
STP configured to ON, priority is level0, mac-learning is enabled
Flow Control is enabled
Mirror disabled, Monitor disabled
Not member of any active trunks
Not member of any configured trunks
No port name
Brocade# show interface ethernet 1/2/1
40GigabitEthernet1/2/1 is up, line protocol is up
Hardware is 40GigabitEthernet, address is 748e.f80c.5f40(bia 748e.f80c.5f40)
Interface type is 40Gig Copper
Configured speed 40Gbit, actual 40Gbit, configured duplex fdx, actual fdx
Configured mdi mode AUTO, actual none
Member of 1 L2 VLANs, port is tagged, port state is FORWARDING
BPDU guard is Disabled, ROOT protect is Disabled
Link Error Dampening is Disabled
STP configured to ON, priority is level0, mac-learning is enabled
Flow Control is enabled
Mirror disabled, Monitor disabled
Member of active trunk ports 1/2/1,1/2/2,1/2/3,1/2/4, primary port
Member of configured trunk ports 1/2/1,1/2/2,1/2/3,1/2/4, primary port
No port name