Brocade Communications Systems Brocade ICX 6650 - Manual (Page 296)

278 Brocade ICX 6650 Administration Guide
53-1002600-01
Syslog messages
A
Informational Bridge topology change, vlan <vlan-id>,
interface <portnum>, changed state to
<stp-state> A Spanning Tree Protocol (STP) topology
change has occurred on a port.
The <vlan-id> is the ID of the VLAN in which
the STP topology change occurred.
The <portnum> is the port number.
The <stp-state> is the new STP state and
can be one of the following:
•
disabled
•
blocking
•
listening
•
learning
•
forwarding
•
unknown
Informational Cold start The device has been powered on.
Informational DHCP : snooping on untrusted port
<portnum>, type <number>, drop The device has indicated that the DHCP
client receives DHCP server reply packets
on untrusted ports, and packets are
dropped.
Informational DOT1X : port <portnum> - mac <mac
address> Cannot apply an ACL or MAC filter
on a port member of a VE (virtual interface) The RADIUS server returned an IP ACL or
MAC address filter, but the port is a
member of a virtual interface (VE).
Informational DOT1X : port <portnum> - mac <mac
address> cannot remove inbound ACL An error occurred while removing the
inbound ACL.
Informational DOT1X : port <portnum> - mac <mac
address> Downloading a MAC filter, but MAC
filter have no effect on router port The RADIUS server returned an MAC
address filter, but the <portnum> is a router
port (it has one or more IP addresses).
Informational DOT1X : port <portnum> - mac <mac
address> Downloading an IP ACL, but IP ACL
have no effect on a switch port The RADIUS server returned an IP ACL, but
the <portnum> is a switch port (no IP
address).
Informational DOT1X : port <portnum> - mac <mac
address> Error - could not add all MAC filters The Brocade device was unable to
implement the MAC address filters returned
by the RADIUS server.
Informational DOT1X : port <portnum> - mac <mac
address> Invalid MAC filter ID - this ID
doesn't exist The MAC address filter ID returned by the
RADIUS server does not exist in the Brocade
configuration.
Informational DOT1X : port <portnum> - mac <mac
address> Invalid MAC filter ID - this ID is user
defined and cannot be used The port was assigned a MAC address filter
ID that had been dynamically created by
another user.
Informational DOT1X : port <portnum> - mac <mac
address> is unauthorized because system
resource is not enough or the invalid
information to set the dynamic assigned IP
ACLs or MAC address filters 802.1X authentication failed for the Client
with the specified <mac address> on the
specified <portnum> either due to
insufficient system resources on the device,
or due to invalid IP ACL or MAC address
filter information returned by the RADIUS
server.
Informational DOT1X : port <portnum> - mac <mac
address> Port is already bound with MAC
filter The RADIUS server returned a MAC address
filter, but a MAC address filter had already
been applied to the port.
TABLE 57 Brocade Syslog messages (Continued)
Message level Message Explanation