Brocade Communications Systems Brocade ICX 6650 - Manual (Page 297)

Brocade ICX 6650 Administration Guide 279
53-1002600-01
Syslog messages
A
Informational DOT1X : port <portnum> - mac <mac
address> This device doesn't support ACL
with MAC Filtering on the same port The RADIUS server returned a MAC address
filter while an IP ACL was applied to the
port, or returned an IP ACL while a MAC
address filter was applied to the port.
Informational DOT1X Port <portnum> is unauthorized
because system resource is not enough or
the invalid information to set the dynamic
assigned IP ACLs or MAC address filters 802.1X authentication could not take place
on the port. This happened because strict
security mode was enabled and one of the
following occurred:
•
Insufficient system resources were
available on the device to apply an IP
ACL or MAC address filter to the port
•
Invalid information was received from
the RADIUS server (for example, the
Filter-ID attribute did not refer to an
existing IP ACL or MAC address filter)
Informational DOT1X: Port <portnum> currently used
vlan-id changes to <vlan-id> due to
dot1x-RADIUS vlan assignment A user has completed 802.1X
authentication. The profile received from
the RADIUS server specifies a VLAN ID for
the user. The port to which the user is
connected has been moved to the VLAN
indicated by <vlan-id>.
Informational DOT1X: Port <portnum> currently used
vlan-id is set back to port default vlan-id
<vlan-id> The user connected to <portnum> has
disconnected, causing the port to be moved
back into its default VLAN, <vlan-id>.
Informational DOT1X: Port <portnum>,
AuthControlledPortStatus change:
authorized The status of the interface controlled port
has changed from unauthorized to
authorized.
Informational DOT1X: Port <portnum>,
AuthControlledPortStatus change:
unauthorized The status of the interface controlled port
has changed from authorized to
unauthorized.
Informational Enable super | port-config | read-only
password deleted | added | modified from
console | telnet | ssh | web | snmp
OR
Line password deleted | added | modified
from console | telnet | ssh | web | snmp A user created, re-configured, or deleted an
Enable or Line password through the Web,
SNMP, console, SSH, or Telnet session.
Informational ERR_DISABLE: Interface ethernet
<port-number>, err-disable recovery timeout Errdisable recovery timer expired and the
port has been reenabled.
Informational ERR_DISABLE: Interface ethernet 16,
err-disable recovery timeout If the wait time (port is down and is waiting
to come up) expires and the port is brought
up the following message is displayed.
Informational ERR_DISABLE: Link flaps on port ethernet 16
exceeded threshold; port in err-disable state The threshold for the number of times that
a port link toggles from “up” to “down” and
“down” to “up” has been exceeded.
Informational Interface <portnum>, line protocol down The line protocol on a port has gone down.
The <portnum> is the port number.
Informational Interface <portnum>, line protocol up The line protocol on a port has come up.
The <portnum> is the port number.
TABLE 57 Brocade Syslog messages (Continued)
Message level Message Explanation