Toshiba Satellite 2430-301 - Manual (Page 184)

AT Commands
Satellite 2430 Series H-12
Satellite 2430 Series Version
1
Last Saved on 04/04/2003 13:35
ENGLISH using Euro_M.dot –– Printed on 04/04/2003 as IM_243EN
&W Store current configuration
Saves the current (active) configuration (profile), including
S-Registers.
The current configuration comprises a list of storable parameters
illustrated in the &V command. These settings are restored to
the active configuration upon receiving a Zn command or at
power up. Refer to the &V command.
&W
Stores the current configuration.
&Zn=x Store telephone number
This command is used to store up to four dialling strings in the
modem’s nonvolatile memory for later dialling. The format for the
command is &Zn=“stored number” where n is the location 0-3 to
which the number should be written. The dial string may contain
up to 40 characters. The ATDS=n command dials using the
string stored in location n.
Result codes:
OK n=0,1,2,3
ERROR Otherwise
\Nn Error control mode selection
This command determines the type of error control used by the
modem when sending or receiving data.
\N0
Buffer mode. No error control.
\N1 Same as \N0 .
\N2 MNP or disconnect mode. The modem attempts to
connect using MNP2-4 error control procedures. If this
fails, the modem disconnects.
This is also known as MNP reliable mode.
\N3 V.42, MNP, or buffer (default).
The modem attempts to connect in V.42 error control
mode. If this fails, the modem attempts to connect in
MNP mode. If this fails, the modem connects in buffer
mode and continues operation. This is also known as
V.42/MNP auto reliable mode.
\N4 V.42 or disconnect. The modem attempts to connect in
V.42 error control mode. If this fails, the call will be
disconnected.
\N5 V.42. MNP or Buffer (same as \N3).
\N7 V.42. MNP or Buffer (same as \N3).
Result Codes:
OK
n=0,1,2,3,4,5,7
ERROR Otherwise