Toshiba Satellite 2430-301 - Manual (Page 65)

Getting Started
Satellite 2430 Series 3-10
Satellite 2430 Series Version
1
Last Saved on 04/04/2003 13:35
ENGLISH using Euro_M.dot –– Printed on 04/04/2003 as IM_243EN
Data save in hibernation mode
When you turn off the power in hibernation mode, the computer takes a
moment to save current memory data to the hard disk. During this time,
the Built-in HDD indicator will light.
After you turn off the computer and memory is saved to the hard disk,
turn off the power to any peripheral devices.
Do not turn the computer or devices back on immediately. Wait a moment
to let all capacitors fully discharge.
Standby mode
In standby mode the power remains on, but the CPU and all other
devices are in sleep mode.
If the computer is not used or accessed in any way, including receipt of e-
mail, for 30 minutes when the AC adaptor is connected, the computer will
automatically enter Standby mode (TOSHIBA Power Management Utility
default).
To restore operation, press the power button or press any key.
If a network application is active when the computer automatically enters
Standby, it might not be restored when the computer wakes up from
standby. To prevent the computer from automatically entering standby
mode, disable Standby in the TOSHIBA Power Management Utility. Open
the TOSHIBA Power Management Utility and click the Power Save Modes
tab. Next select either an AC Power or Battery Power option and then
click details. When the details page comes up, you can disable the
Standby setting be moving the slider to Never. That action, however, will
nullify the computer’s Energy Star compliance.
Standby precautions
Before entering Standby mode, be sure to save your data.
■ Do not remove/install memory or remove power components:
■ Do not remove/install the memory module. The computer or the
module could be damaged.
■
Do not remove the Battery Pack.
In any of the above cases, the standby configuration will not be saved.
If you carry the computer on board an aircraft or into a hospital, be sure to
shut down the computer in hibernation mode or in shutdown mode to
avoid radio signal interference.