Blaupunkt AntaresT60 - Manual (Page 16)

16
RADIO OPERATION
Switching REG on/off
➮
Press # /AF for approx. 1 second until
REGIONAL ON or REGIONAL OFF ap-
pears in the display.
REG will appear in the display when this RDS
function has been activated.
Selecting the memory bank/
waveband
With this radio, you can tune into stations on
the FM and AM (MW and LW) wavebands.
➮
Press BND to switch between the wave-
bands or memory banks.
Selecting a radio station
There are different ways in which you can
select a radio station.
Automatic station selection
(seek tuning)
➮
Press or .
The radio will tune into the next station within
reception range.
Selecting seek tuning sensitivity
Use this function to determine whether the
radio tunes into only those stations with strong
reception signals or into weaker stations as
well.
➮
Press * to switch between high sensitiv-
ity (stations with weaker signals) and low
sensitivity (local stations).
lo will light up in the display if you have se-
lected low sensitivity.
In the DSC menu you can also select the
degree of sensitivity for LO (local) and DX
(distant) reception.
➮
Press OK to access the DSC menu.
➮
Press / to select the menu item
Radio .
➮
Press OK.
➮
Press / to select the menu item
Sensitivity .
➮
Press OK.
➮
Press / to select the menu item DX
or LO .
➮
Press OK.
➮
Press / to select the desired setting.
➮
Press OK.
➮
Press SRC to exit the DSC menu.
Searching for/selecting radio stations
manually
You can also select a radio station manually.
➮
Press or .
Note:
You will not be able to select a station manu-
ally unless AF is deactivated.
Entering a station frequency directly
For FM and FMT you can also enter a station
frequency directly with the number buttons.
➮
Press 0.
➮
Enter the frequency without adding the
decimal point.
➮
If you want to delete your entry, press
CLR.
Paging through station networks
If one radio station has several different pro-
grams, you can page through this “station
network”.
➮
Press or to tune into the next station
in the station network.
Note:
To use this function, you must have activated
the RDS convenience functions first.
Storing stations manually
➮
Select the desired memory bank: FM,
FMT, MW or LW.
➮
Select the desired station.