Radio operation, Recalling stored stations, Switching between stereo and mono – Blaupunkt AntaresT60 User Manual
Page 17: Selecting radiotext display
17
ENGLISH
DEUTSCH
FRANÇAIS
IT
ALIANO
NEDERLANDS
SVENSKA
ESP
AÑOL
PORTUGUÊS
RADIO OPERATION
For the station presets 1 - 9
➮
press one of the buttons 1 - 9 for approx.
1 second until you hear a beep.
For the station presets 10 - 19 (for FM only)
➮
press 1 briefly and
➮
then press one of the button 0 - 9 for
approx. 1 second until you hear a beep.
Storing the stations with the
strongest signals automatically
(Travelstore)
You can automatically store the nine stations
with the strongest reception signals in the
region (FM only). These stations will be stored
in the FMT memory bank.
Note:
Any stations already stored in this memory
bank will be deleted automatically.
➮
Press BND/TS.
The storing process will begin.
TRAVELSTORE
will flash in the display.
Once the storing process has been com-
pleted, the radio station stored on preset 1 in
the FMT memory bank will begin to play. The
station list will appear in the display for sev-
eral seconds.
Recalling stored stations
There are different ways in which you can
recall stored radio stations.
Numbers buttons
➮
Select the memory bank or the wave-
band.
For station presets 1 - 9
➮
press the desired button from 1 - 9
briefly.
For station presets 10 - 19
➮
first press the 1 briefly
➮
then press the desired button from 0 - 9
within 2 seconds.
Menu
➮
Press BND to select the memory bank
or waveband.
➮
Press MEM.
A menu listing the stations stored will appear
in the display.
➮
Press / to select the desired station.
➮
Press OK to tune into the station se-
lected.
Switching between stereo and
mono
When you switch the Radiophone on, it will
automatically begin to play in stereo. If sta-
tion reception should begin to deteriorate, the
Radiophone will automatically switch to mono.
Selecting Radiotext display
➮
Press OK to access the DSC menu.
➮
Press / to select the menu item
Radio
.
➮
Press OK.
➮
Press / to select the menu item
Radiotext
.
➮
Press OK.
➮
Press / to select one of the following
settings:
Off
- switched off
On
- switched on
On/Eng. off - switched on only when the
engine is off
➮
Press OK to confirm your selection.
➮
Press SRC to exit the DSC menu.