Bad Boy Mowers BAD BOY 02.9812.0001C - Manual (Page 23)

I NSTALLATION : I NSTALLATION P ROCEDURES
0 2. 9 8 1 2. 0 0 01 C 13
2
Installation Procedures
Unpacking and Attaching Hanging Brackets
The Bad Boy™ Spot Luminaire can be hung horizontally or vertically from any structure designed to
accommodate the load of this moving luminaire. Two provided Hanging Bracket Assemblies
(21.9812.0863) are used to attach the luminaire to a truss pipe. The Hanging Brackets consist of a pre-
assembled bracket with a Mega-Claw Truss Hook.
To unpack and attach brackets:
Step 1. Unlatch and remove case lid (
Figure 2-2 ).
Step 2. Remove Power Cord, Safety Cables, and Hanging Brackets from case.
Step 3. Tilt luminaire enclosure upright as shown.
Step 4. Install Hanging Brackets as follows:
a. Choose orientation. Brackets may be attached in one of four positions. Refer to Figure
2-3 for a diagram of the orientation options.
b. Orient Hanging Bracket in desired direction over two attachment buttons on bottom of
upper enclosure ( Figure 2-2 ).
c. Place Hanging Bracket down over buttons and slide until bracket locks into place (you
will hear a "click" when bracket is locked).
Figure 2-2: Opening Case and Attaching Hanging Brackets
Hanging Bracket (2)
Safety Cable (2)
Power Cord
Case