Troubleshooting, Troubleshooting guide – Bad Boy Mowers BAD BOY 02.9812.0001C User Manual
Page 58
B
AD
B
OY
™ S
POT
L
UMINAIRE
U
SER
M
ANUAL
4 8
02.9812.0001C
Troubleshooting
Troubleshooting Guide
The following table provides a list of common start-up problems and possible solutions.
Symptom
Solution(s)
Refer to...
No power to luminaire.
Ensure power cable is properly connected to Neutrik
input connector.
Ensure power is switched on at source (mains, discon-
nect box, etc.)
n/a
No console control.
Ensure DMX512 or Ethernet data cable is properly
connected.
Ensure DMX512 address setting is correct.
DMX512 control not working cor-
rectly throughout daisy-chain.
Ensure data cables are correctly configured.
Ensure termination connector is installed at last lumi-
naire in data link.
Lamp does not strike at power-up.
Configure lamp to start at power-up.
Comm LED is red indicating that no
valid DMX or Ethernet signal is
detected.
Ensure DMX512 or Ethernet data cable is properly
connected.
Check console.
No Ethernet control.
Ensure that luminaire is not also receiving a DMX sig-
nal. If both valid DMX and Ethernet control are being
received, DMX control will take precedence.
Beam obstructed by gobo in open
position.
Set new gobo zero position.
Luminaire won’t take software
update.
Remove active control (DMX512 or Art-Net).