Bad Boy Mowers BAD BOY 02.9812.0001C - Manual (Page 34)

B AD B OY ™ S POT L UMINAIRE U SER M ANUAL
2 4 02.9812.0001C
Ethernet (Art-Net) Comm
The starting address for Ethernet (Art-Net) systems is programmed using the CONFIG menu.
To program a starting address:
Step 1. At Home screen, press CONFIG panel.
Step 2. At Configuration screen, press DMX ADDRESS panel.
Step 3. At numeric keypad, enter new starting address and press ENTER.
Figure 2-14: Setting Starting Address (Ethernet Control)
To select an Art-Net universe:
If using Ethernet control, a universe must be selected in addition to the DMX address. The universe
can be selected and displayed in either alphabetic or numeric mode (using the UNIV FORMAT
screen). The alpha mode is useful to differentiate universes from DMX addresses and is the standard
on Virtuoso® control systems. In alpha mode, the valid universes are A-JE, selected from the
alphabetic keypad (as shown below). If in numeric mode, the valid universes are 0-255, selected from
the numeric keypad.
Figure 2-15: Selecting a Universe (Ethernet Control)
Note: Refer to "Menu System" on page 30 for more information about the Menu Touchscreen.
Control Input Type