Bosch MegaPixel IP Camera NWC-0900 - Manual (Page 43)

MegaPixel IP CamerasSoftware | en 41
Bosch Security Systems User Manual F.01U.064.422 | V 1.0 | 2007.03
NOTE! DiBos8 automatically scales an image to a 4 (H) x 3 (V)
aspect ratio for display. Always maintain the selected image
area to be displayed at a 4x3 aspect ratio.
Table 4.1 HTTP command string parameters
PARAMETER DESCRIPTION COMMENT
<ip_address> The IP address of the camera e.g. 192.168.2.75
/image? Image request command
<resolution_value> Specifies whether the cam-
era should decimate the
image by the factor of 2 in
each direction
full or half, e.g. res=
half=> an image with
1600x1200 will
become 800x600
<x0_value> The left hand coordinates of
the requested image window
default: x0=0
<y0_value> The top coordinates of the
requested image window
default: y0=0
<x1_value> The right hand coordinates of
the requested image window
e.g. x1=1600
<y1_value> The bottom coordinates of
the requested image window
e.g. y1=1200
<quality_value> The compression quality of
the JPEG image with the
range from 1 to 21
default: quality=12.
21 gives highest quality
<doublescan_value> Doublescan is the parameter
that allows the user to spec-
ify whether the camera
should delay the image out-
put until the new image is
scanned (doublescan=0) or
the image request should be
serviced immediately by out-
putting the content of the
current image in the image
buffer (doublescan=1) (the
image will be displayed faster
on the screen)
e.g. doublescan=0
<port_no> The camera sends "ismotion"
to the specified port No. if
motion is detected and
"nomotion" if motion is not
detected.
e.g. port_no=3028
This parameter is
optional.