Sharp LC-60UQ10KN - Manual (Page 18)

16
Searching for satellite broadcasts
Press a/b to select “Satellite search”, and then
press ;.
Digital search
Analogue search
Satellite search
• The antenna connection setting screen is displayed.
Single satellite
2 satellites on toneburst switchbox
Max. 4 satellites on DiSEqC multiswitch
Communal satellite system
NOTE
• You can select the antenna connection method from the
four types. Consult your dealers before using a method
other than “Single satellite”.
E “Single satellite” setting
1 Press a/b to select “Single satellite”, and then
press ;.
2 Press a/b/c/d to select your favorite
satellite, and then press ;.
Euro Bird 1
Atlantic Bird 1
NOTE
• Follow the instructions on the screen for “2 satellites
on toneburst switchbox”, “Max. 4 satellites on DiSEqC
multiswitch” and “Communal satellite system” settings.
• To set multiple satellite channels, go to “Max. 4 satellites
on DiSEqC multiswitch”.
• When a power supply is needed for your satellite
antenna, follow the procedure below in order to supply
the voltage specified by your service provider, etc.:
Go to “TV Menu” > “Setup” > “View setting” > “Channel
settings” > “Antenna setup-DIGITAL” > “Satellite setup” >
“Change setting” > “Communal satellite system”.
E Search start:
DVB-S/S2 channel searching.
1 Press c/d to select “Yes”, and then press ;.
• To change the settings for “Scrambled stations”,
press a/b to select the item to be reconfigured
and then perform “Search start”.
Yes No
Scrambled stations
Search start Start search?
[Yes]
2 The TV searches for and stores all the receivable
TV stations according to their settings and the
connected antenna.
• Select “Yes” to sort the search result in alphabetical
order.
• To abort the initial auto installation in progress,
press 6.
NOTE
• Scrambled stations: Specifies if you need to choose
pay-TV services.
• Follow the procedure to perform “Manual search” if you
want to configure the frequency or symbol rate and start
to search after performing the auto searching during the
initial auto installation.
− Go to “TV Menu” > “Setup” > “View setting” >
“Channel settings” > “Programme setup” > “Satellite
setting” > “Manual search”.
Initial auto installation