Sharp LC-60UQ10KN - Manual (Page 43)

41
Buttons for “Manual adjust” operation
Lock Press R button.
When the service is locked, you must enter your
PIN whenever you tune to the service.
CH skip Press G button.
Services with a ✔ mark are passed over when
pressing
:r/s on the TV or remote control
unit.
Delete Press Y button.
The selected service is deleted. If you want
to watch the service you deleted once again,
perform “Auto installation”, “Additional search”,
or “Manual search”.
Sort Press B button.
The item position of services can be sorted.
1 Press a/b to select the service whose
item position you want to move, and then
press
;.
2 Press a/b to move it to the desired
position, and then press ;.
3 Repeat steps 1 and 2 until all desired
service items are sorted.
E Favourite network selection
When the country setting is “Norway” and DTV,
the user may select their preferred network. The
service sorting will be changed in accordance with
the preferred network. If a conflict occurs between
multiple networks, this function allows you to select
your preferred network.
1 Press a/b to select the desired network.
2 Press ; to set the network selected.
Cable
You can reconfigure the following settings when you
select “Cable” in the initial auto installation or the
“Auto installation” menu.
E Additional search
Use this menu to add new services automatically
after “Digital search” in the “Auto installation”
menu has been completed. Follow steps 1 to 5 in
Searching for cable broadcasts on page 15.
E Manual search
Normal: Add new services within a specified
frequency band. After setting the items
on the following screen, the TV starts
searching.
Special: Use this option only when no channels can
be found by "Normal".
• Refer to the table about menu items in the centre
column on page 15.
Frequency
Symbol rate
QAM modulation
Search start
MHz
E Manual adjust
This function is the same as in “Terrestrial”. Refer to
“Manual adjust” in “Terrestrial”.
NOTE
• Some functions may not display or be selectable
depending on the country setting or cable provider
selection.
Satellite setting
Before selecting the type of search in “Satellite
setting”, you need to select the satellite broadcast.
SAT2 [Hot Bird 13E]
SAT3 [None]
SAT4 [Turksat]
E Additional search
Use this menu to add new services automatically
after auto installation has been completed. Follow
steps 1 to 2 in the right column on page 16.
E Manual search
Normal: Add new services within a specified
frequency band. After setting the items
on the following screen, select “Yes” from
“Search start” menu.
Special: Use this option only when no channels can
be found by "Normal".
Band [Vert/Low]
Frequency
Symbol rate
Search start
Vert/High
Horiz/Low
Horiz/High
Vert/Low
E Manual adjust
This function is the same as in “Digital setting”.
Refer to “Manual adjust” in “Digital setting”.
Basic adjustment