Sharp LC-60UQ10KN - Manual (Page 7)

5
Attaching the stand unit
• Before attaching (or detaching) the stand, unplug the AC cord.
• Before performing work, spread cushioning over the
surface on which you will be laying the TV. This will
prevent it from being damaged.
• Be sure that two or more persons attach the stand.
CAUTION
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
• After attaching the stand to the TV, do not hold the
stand when you put up, set up, move or lay down the TV.
• Do not remove the stand from the TV unless using a
wall mount bracket to mount it.
1 Confirm that there are 14 screws (twelve M5
screws and two M4 screws) supplied with the
stand unit.
2 Attach the supporting post to the stand base.
1 Insert the claws of the supporting post into
the stand base.
2 Secure the post and the base using the M5
screws (length: 14 mm) and a screwdriver.
3 Insert the stand into the openings on the bottom
of the TV (hold the stand so it will not drop from
the edge of the base area).
• Make sure that the stand is firmly inserted into the
TV. Improper installation may result in tilting of the
TV set.
Soft cushion
4 Insert and tighten the M5 screws (length: 14 mm)
into the holes on the rear of the TV.
M5 screws
5 Attaching the stand cover.
1 Insert the stand cover.
2 Insert and tighten the M4 screw (length:
8 mm) into the holes of the stand cover.
• Tighten the screw by pressing the bottom of the
stand base to the TV side.
M4 screw
NOTE
• To detach the stand unit, perform the steps in reverse
order.
• A screwdriver is not supplied with this product.
• In the installation procedure, be careful not to catch
your fingers between the TV set and the floor.
Preparation
M5 screws