Sharp LC-60UQ10KN - Manual (Page 50)

48
Additional features
Option
Illumination
This function makes the LED on the front of TV
illuminated in several ways.
Go to “TV Menu” > “Setup” > “Option” >
“Illumination”.
Item
Off The LED is not illuminated.
Standby
The LED is illuminated while the TV is
in standby mode.
Watch
The LED is illuminated while you watch
TV.
Always The LED is illuminated all the time.
NOTE
• The factory default for this item is “Watch”. Set to “Off”
if you do not want the LED to illuminate.
• The LED is illuminated in white for 2D mode.
• The LED is illuminated in blue for 3D mode.
Option
Quick start
You can reduce the TV’s start-up time after turning
on the power with the remote control unit.
Go to “TV Menu” > “Setup” > “Option” > “Quick
start”.
Item
On
The TV quickly starts up from standby.
Around 15 W or more of power
consumption is required during
standby.
On (Wallpaper)
The TV enters wallpaper mode when in
standby condition.
Off
Power consumption is small during
standby.
Option
Wallpaper setting
This function is available only when “Quick start” is
set to “On (Wallpaper)”.
Activating the function will display still images when
the TV is in standby mode.
Data source
For the wallpaper, you can select either the still
images pre-installed in the TV or your favourite still
images stored in the USB device or SD memory
card.
Item
Pre-installed
The images pre-installed in the TV will
be displayed in a slideshow.
SD/SDHC/USB
Images stored for the wallpaper will
appear.
If only a single still image is stored in
the USB device or SD memory card,
that image will be displayed as the
wallpaper. When there are multiple still
images in the memory, all the images
will be displayed in a slideshow.
NOTE
• Images are displayed as a slideshow in 3-minute
intervals.
• As a USB device or SD memory card cannot be
detected immediately after the TV is turned on from
standby mode, the wallpaper pre-installed in the TV
may be displayed even when “Data source” is set to
“SD/USB”. To display the SD/USB Wallpaper, turn on
the power and wait 10 seconds before turning off the
power.
• When in the wallpaper function, do not perform any
OAD operations or EPG searches.
• A timer set for recording or watching a programme will
take priority 2 minutes before the programme starts.
E When you display images by using the
USB device or SD memory card:
• Create a folder named “WP” in the root directory of the
USB device or SD memory card (the first directory when
the USB device is opened), and store into the folder the
still images you want to display for the wallpaper.
• You must insert the USB device or SD memory card into
the TV before it is turning off.
Timer setting
You can set the length of time the TV will remain in
the Wallpaper mode (3 hours/6 hours/12 hours/24
hours).
NOTE
• Setting “Quick start” to “On” consumes more power.
• No buttons except for
a work even while the still
images are being displayed.
• If the ready-for-use USB device is not inserted, the still
images pre-installed in the TV will be displayed in a
slideshow even when “Data source” is set to “USB”.
• The still images will be displayed until the set time has
elapsed.
• If you do not want to use the wallpaper as described
above, set “Quick start” to “On” or “Off”.
Option
Boot picture
With this function activated, the SHARP logo will be
displayed when you turn on the TV.
NOTE
• This function is not available when the “Quick Start” is
set to “On”.
Useful viewing functions