Sharp XE-A213 - Manual (Page 52)

50
Example 2: Job code type programming (programming starting from the press of s .)
Entering character codes with numeric keys on the keyboard
For entering numerals, letters or symbols, enter a character code using numeric keys and press the numeric key
:
.
For the character codes, please refer to the alphanumeric character code table on the next page. By doing this,
you can program characters other than those on the key tops. For entering numerals, letters or symbols using
character keys, refer to "Using character keys" on page 14.
• Double-size characters can be made by entering the character code 253 or pressing the
W
key. “W” is
displayed when double-size characters entry is selected as shown in the operator display example below.
• All three digits of the character code MUST be entered (even if it starts with zero).
To program the word “SHARP” in double-size characters
253
:
083
:
072
:
065
:
082
:
080
:
S H A R P
253 :
065
:
_ W
065
=A_ W
Characters entered are displayed here.
Cursor
Character code
Characters: Indicating double size character of "A"
Operator display Key operation example
To repeat
(depending on programming)
Guidance message is changed
after a new job code entry.
s 1 @
50
s
A
Job code entry
¥ Guidance message is displayed.
Parameter entry
Registration of parameter
To terminate
MACHINE NO.
50
ENTER[TL/NS]KEY
0.00
Operator display Key operation example
A213_3 FOR THE MANAGER(SEEG) 06.4.28 8:33 PM Page 50