Neff C47C62N3GB - Manual (Page 10)

10
First use
Before first use, heat the empty appliance with é Steam
cooking for 20 minutes at 100 °C. Do not open the appliance
door during this time. The appliance is automatically calibrated
(see section: Automatic calibration).
1. Press the operating mode selector so that it pops out.
The appliance switches on.
2. Fill and insert the water tank (see section: Filling the water
tank).
Before using for the first time, moisten the seal in the tank
cover with a little water.
3. Turn the operating mode selector round to é Steam
cooking.
4. Press the Start button.
The appliance heats up to 100 °C. The cooking time
(20 minutes) does not start to count down until the set
temperature has been reached. Do not open the appliance
door during this time.
The cooking operation ends automatically and an audible
signal sounds.
5. Press the KJ clock function button to exit the clock function.
6. Turn the operating mode selector back to the Û position and
click in place to turn off the appliance.
Leave the appliance door ajar until the appliance has cooled
down.
Cleaning the accessories before use
Using soapy water and a soft cloth, clean the accessories
thoroughly before first use.
Fitting the grease filter in place
Hook the enclosed grease filter onto the hot air grille in the
back wall of the cooking compartment.
Leave the grease filter in the cooking compartment for all
applications.
:
Risk of injury!
You could hurt yourself on the grease filter hooks. Always clean
the grease filter with care. Always place the grease filter in the
dishwater so that the hooks for fixing it in place are facing
downwards.
Clean the grease filter with hot soapy water or in the
dishwasher every time heavy dirt deposits have been left
behind after cooking.
Operating the appliance
In this section, you can read about
■
how to fill the water tank
■
how to switch the appliance on and off
■
what to note after each cooking operation
Filling the water tank
When you open the appliance door, you will see the water tank
on the right-hand side.
Caution!
Use of unsuitable liquids may damage the appliance
■
Only use fresh tap water, softened water or uncarbonated
mineral water.
■
If your tap water is very hard, we recommend that you use
softened water.
■
Do not use distilled water, highly chlorinated tap water
(> 40 mg/l) or other liquids.
You can obtain information about your tap water from your
water supplier. The water hardness can be checked with the
test strips enclosed.
Fill the water tank before each use:
1. Open the appliance door and take out the water tank (fig. A).
2. Fill the water tank with cold water up to the “max” mark (fig.
B).
3. Close the tank cover until you feel it engage.
4. Slide in the water tank all the way (fig. C).
The tank must be flush with the water tank recess (fig. D).
PD[
% $
' &