Bakers Pride VH1828E - Manual (Page 15)

13. CONVEYOR REMOVAL
14. CONVEYOR INSTALLATION
Extensive Engineering went into designing your oven for ease of cleaning. One SPECIAL
FEATURE is the ability to remove the conveyor belt assembly straight out the font of the oven.
Follow this procedure, using the diagram provided: (See drawing below)
a) Remove any extension trays present, rotating them upwards to clear the conveyor frame.
Flanges on the trays hook around the ends of the frame.
b) Remove the two crumb pans.
c) Remove the upper outer side covers, which have the adjustable baffles attached with pins.
The covers are held in place with hand-twist fasteners. Turn these fasteners 90°
counterclockwise to loosen, and 90° clockwise to tighten.
d) It is not necessary to remove the outer lower side covers.
On Dual Air Models VH-, VHVA Series ovens, the outer upper and lower covers
are symmetrical, and can be mounted on either side of the oven.
e) Open the front hinged door.
f) Carefully supporting both right and left sides of the conveyor, lift the front edge slightly and
pull towards you, watching as the drive shaft pulls out of the gearmotor coupling.
Installing the conveyor belt assembly is done in exact reverse order to it’s removal. The MOST IMPORTANT
POINT is to properly align the drive shaft pin with the gearmotor coupling. If the drive shaft pin must be
wedged into place for installation, the coupling location needs to be adjusted. See Section 6a for this
procedure.
NOTE: 1828E
DO NOT FORCE THE DRIVE PIN INTO THE COUPLING IF THEY DO NOTALIGN.
15
IF EXTENSION TRAYS ARE
PRESENT, ROTATE THEM
UPWARDS TO REMOVE FROM
CONVEYOR FRAME
IF EXTENSION TRAYS ARE
PRESENT, ROTATE THEM
UPWARDS TO REMOVE FROM
CONVEYOR FRAME
UPPER OUTER SIDE
COVER WITH
ADJUSTABLE BAFFLE
UPPER OUTER SIDE
COVER WITH
ADJUSTABLE
BAFFLE