Bakers Pride VH1828E - Manual (Page 8)

&
6. SYSTEM CHECK
a) Insure that the conveyor belt assembly is installed correctly, with the drive-shaft pin fitting firmly into
the coupling that protrudes from the Power Control Box gearmotor output shaft. Visually check that
the belt is flat and parallel to the countertop surface. If the belt is not parallel to the countertop, it may
be necessary to re-align the gearmotor output shaft to the conveyor belt drive shaft pin. Follow this
procedure:
1.
2. Re-aligning the coupling / driven-shaft pin requires opening the Power Control Box door.
3. Insert a hex-head nut-driver tool to loosen the (4) screws that fasten the gearmotor to the box
side panel.
4. Re-align the coupling to the conveyor belt drive shaft pin. If this is done properly, the driven-
shaft pin will fit snuggly into the slot of the gearmotor coupling.
5. When alignment is correct, re-tighten the (4) screws at the gearmotor before closing the
door.
The conveyor belt is capable of traveling either Left-to-Right (standard), or Right-to-Left (optional).
Direction of travel is determined by looking at the conveyor oven from the front of the unit. Direction
of travel is controlled by a “Reversing Switch” that is located inside the control box containing the
gearmotor. If the direction of travel needs to be reversed, follow this procedure:
1.
2. Reversing the conveyor belt requires opening the Power Control Box door.
3. Locate a small rocker switch mounted just inside the control box, either black or orange in
color. Two wires are connected to it.
4. Change the switch position to the opposite setting. No other changes are necessary.
5. Close and securely fasten the door.
6. Re-connect power to the unit.
b)
NOTE:
OTHERWISE, FATAL DAMAGE WILL OCCUR TO THE GEARMOTOR,
CAUSING THE CONVEYOR BELT TO STOP MOVING. THE GEARMOTOR WILL NEED TO BE
REPLACED DUE TO INTERNAL STRUCTURALDAMAGE.
DISCONNECT THE POWER SUPPLY BEFORE SERVICING COMPONENTS INSIDE
EITHER OF THE CONTROL BOXES. SERIOUS INJURY, INCLUDING DEATH, MAY
OCCUR IF CONTACT IS MADE TO INCOMING POWER.
CHANGE THE REVERSING SWITCH ONLY WHEN POWER IS DIS-CONNECTED TO
THE CONVEYOR OVEN.
DISCONNECT THE POWER SUPPLY BEFORE SERVICING COMPONENTS INSIDE
EITHER OF THE CONTROL BOXES. SERIOUS INJURY, INCLUDING DEATH, MAY
OCCUR IF CONTACT IS MADE TO INCOMING POWER.
CONVEYOR BELT
FITS INTO UNIT
FROM FRONT
DRIVE SHAFT
PIN ALIGNS
WITH COUPLING
OF GEARMOTOR
CRUMB PANS MOUNT
IN CONVEYOR FRAME
HINGED
FRONT DOOR