Bay Technical Associates BayStack 304 - Manual (Page 46)

Using the BayStack 303 and 304 Ethernet Switches
2-12 893-01010-A
To use the console port, you need the following equipment:
• A terminal or TTY-compatible terminal, or a portable computer with a serial
port and the ability to emulate a terminal
The terminal should have the following settings:
— 9600 baud
— No parity
— 8 bits
— 1 stop bit
— Window Terminal Emulator option set to NO
— Terminal Preferences—Function, Arrow, and Control keys active
• A UL-listed straight-through RS-232 cable with a female DB-9 connector for
the console port on the switch
The other end of the cable must have a connector appropriate to the serial port
on your computer or terminal. (Most terminals or computers use a male
DB-25 connector.)
Any cable connected to the console port must be shielded to comply with
emissions regulations and requirements.
See “Console Port Connector ” on page 1-6 for a description of the pin
assignments.
To connect a terminal to the console port, follow these steps:
1. Set the terminal protocol as described previously.
2. Connect the terminal (or a computer in terminal-emulation mode) to the
console port using the RS-232 cable.
a. Connect the female connector of the RS-232 cable directly to the
service port on the switch, and tighten the captive retaining screws
(see
Figure 2-6 ).
89301010.BK Page 12 Tuesday, June 10, 1997 8:00 PM