Bay Technical Associates BayStack 304 - Manual (Page 53)

Installing the BayStack Switches
893-01010-A 2-19
2. Type 1 to select 1---Switch Network Configuration from the System
Configuration menu.
This selection displays the Switch Network Configuration menu (see
Figure 2-11 ).
Figure 2-11. Switch Network Configuration menu
3. Type 1 in the command line.
This action refreshes the screen and displays the current IP address value.
4. Enter the IP address of the switch in the command line.
This action refreshes the screen and displays the new IP address value in the
field on the menu.
Note: IP addresses are written as four decimal numbers (for example,
123.123.123.123). Each decimal number represents an 8-bit octet. When
strung together, the four octets form the 32-bit Internet address. This
notation is called dotted-decimal notation. The largest possible value of a
field in a dotted-decimal number is 255, which represents an octet of all
ones.
*****************************************************************************
Bay Networks BayStack 303 Ethernet Switch
IP Address: [0.0.0.0]
Mac Address: [00:00:81:12:12:12]
Software Version: [1.0]
System Up Time: [0d:00h:00m:00s]
Switch Status: [Switching]
*****************************************************************************
Switch Network Configuration
1 -- IP Address
2 -- IP Subnet Mask Address
3 -- Default Gateway Address
4 -- Spanning Tree Protocol
5 -- Telnet Access
6 -- Telnet password
Enter Command ([ESC]---Previous Screen [Space]---Refresh Screen)
89301010.BK Page 19 Tuesday, June 10, 1997 8:00 PM