Barco NIO E-2620 - Manual (Page 123)

Driver re-installation, updates or removal
Nio® medical display systems 123
3. To update the driver, clear the checkbox next to “NioWatch
Setup” (figure 59) and click “Install”.
Figure 59
4. For Windows 2000 or Windows XP please turn to Step 6 on
page 48 in the section titled “Windows 2000 BarcoMed Nio
software installation” and follow the instructions to finish
reinstalling or updating your BarcoMed Nio driver.
When the driver has finished installing, click “Finish”. Then click
“Finish” again.
Reboot the system when prompted and then reset the resolution
of your displays if necessary.
Uninstalling the BarcoMed Nio driver or Barco NioWatch software
Special Note: The BarcoMed Uninstaller is supported only on
Windows 2000 and Windows XP.
To remove the BarcoMed Nio display controller driver from your
system you must be logged in using an account with
administrator privileges.
Uninstalling the BarcoMed Nio driver
1. Insert your BarcoMed Nio Software CD into your computer’s
CD drive. If the “BarcoMed Product Installation Wizard”