Barco NIO E-2620 - Manual (Page 40)

Display installation
40 Nio® medical display systems
2. Connect the output of the 12V DC power supply to the DC
input of the display.
3. Connect one end of the proper power cable to the AC input
of the 12V DC power supply.
4. Connect the other end of the power cord to a grounded
power outlet.
Video connection
Connecting DVI cables: One display:
Figure 14
1. Connect one end of the DVI cable to the DVI input of the
display.
2. Connect the other end of the DVI cable to the DVI connector
of the display controller board. If this board has 2 video
heads (2 video outputs), connect to output Vid 1 (Head A).
Connecting DVI cables: Two displays:
1. Connect the left display (when looking at the front side) to
display controller output Vid 1 (Head A) as described above.
2. Connect the second display to output Vid 2 (Head B).
(1)