Philips Aspirateur-robot - Manual (Page 34)

34
14 Error codes
Error code Cause Solution
E0 Rechargeable
battery is empty
Charge the robot.
E1 Wheel lifted The robot is stuck on a threshold or another height
difference. Move it to a flat area.
E2 Floor detection
error
Move the robot to a flat area.
E3 Dust container
error
The dust container is not properly inserted. Insert the dust
container properly. Press the dust container to make it lock
into position with a click(see steps 6 to 8 in ‘Emptying the
dust container’ in chapter ‘Cleaning and maintenance’).
E4 Wheel motor
overload
Check if there is any dirt (hair, fluff etc.) attached to
the wheels. Remove the dirt (see chapter ‘Cleaning and
maintenance’).
E5 Brush motor
overload
Check if there is any dirt (hair, fluff etc.) attached to the
roller brush or side brushes. Remove the dirt (see chapter
‘Cleaning and maintenance’).
E6 Robot motor
overload
Clean the filters and empty the dust container (see chapter
‘Cleaning and maintenance’).
E7 Inner system
error
Set the on/off switch to OFF and then set it to ON again.
E8 Front wheel
slipping or not
moving
Check if the robot can move forward freely and if there
are any objects that block its movements. Check if the front
wheel can turn freely by turning the robot upside down
and moving the wheel with your hand. If the wheel jams,
the wheel may be dirty. Clean the front wheel (see chapter
‘Cleaning and maintenance’).
Check if the rings on both sides of the front wheel are
present. If one or both rings are missing, contact the Philips
Consumer Care Centre.