8 cleaning the side brushes – Philips Aspirateur-robot User Manual

Page 28

Advertising
background image

28

D

Note:

When you put back the front wheel, make sure

the rings are attached on both sides of the wheel.

If one or both bearing rings are missing, contact

the Philips Consumer Care Centre.

7.8 Cleaning the side brushes

1

To remove a side brush from the robot, grab

two arms of the side brush and pull the side

brush upwards with two hands.

2

Remove dust and dirt from the side brush

with the comb end of the cleaning tool or

with your fingers.

3

To remount the side brush, align the hole in

the centre of the side brush with the half-

round mounting pin on the bottom of the

robot and push the side brush into position

4

Repeat steps 1 to 3 to clean the other

side brush.

3

Remove the front wheel from the robot (1)

and remove dust and dirt from the wheel

with the brush end of the cleaning tool (2).

D

Note:

You can find the cleaning tool on the inside of the

dust container compartment cover (see section

‘Emptying the dust container’ in this chapter).

D

Note:

When you remove the front wheel, be careful not

to lose the loose rings on either side. These rings

are intentionally loose to enable easier cleaning.

4

Put the front wheel back into the robot (1).

Then place the front wheel retainer over the

front wheel and press it home until the latch

hooks lock into place with a click (2).

Advertising
This manual is related to the following products: