Bay Technical Associates V79 PDI-1 - Manual (Page 18)

14
4.3.7 REPORT EVENT LATCH DATA COMMAND
The Report Event Latch Data (RL) command instructs the PDI to report the active
state of the initial event and the time the initial event occurred (if time tagging is
enabled). This command does not reset the latch buffer. The Report Event Latch
Data has the following format:
RLc<cr>
where c = Channel# (1 to 16 or 0 for all).
4.3.8 REPORT EVENT COUNTER AND RESET COMMAND
The Report Event Counter and Reset (RO) command instructs the PDI to report
how many times an event has occurred for one or more channels and then reset
the event counter to zero. The Report Event Counter and Reset command has the
following format:
ROc<cr>
where c = Channel# (1 to 16 or 0 for all).
4.3.9 REPORT EVENT LATCH DATA AND RESET COMMAND
The Report Event Latch Data and Reset (RR) command instructs the PDI to
report the active state of the initial event, the time the initial event occurred (if time
tagging is enabled), and then reset the latch buffer. The Report Event Latch Data
and Reset command has the following format:
RRc<cr>
where c = Channel# (1 to 16 or 0 for all).