Bay Technical Associates V79 PDI-1 - Manual (Page 25)

21
5.1.1 CONFIGURATION MAIN MENU
A PDI-1 module installed as Module X will respond to the receiving of
$CONFIG<cr> with an identification block and a menu of the available
configuration options similar to the following:
Copyright (c) Bay Technical Associates,1993
DAC V79 PDI-1 Rev. 1.XX
This Module is X
CONFIGURATION MAIN MENU
Module Status......................1
Sampling Setup.....................2
Reporting Setup....................3
Dynamic Configuration..............4
Exit...............................X
Enter Selection:
NOTE: The only difference in the configuration main menu for the PDI-1 or PDI-
2 modules is the second line in the header showing the module type. All
subsequent menus are the same for both modules. The configuration menus
shown in the following sections are depicted with factory default settings and may
vary slightly in presentation.
Enter the number corresponding to your desired choice. Each choice will invoke a
sub-menu. Each sub-menu is described in the following sections. When you exit
a sub-menu, you will be returned to the configuration main menu. When "Exit" is
selected from the main menu, the PDI will exit from configuration mode and go
into an active data collection mode.