Bay Technical Associates V79 PDI-1 - Manual (Page 27)

23
Type the desired debounce delay time followed by <ENTER>. The debounce
delay is used to guard against erroneous events. An event will not be valid unless
the input channel has remained at a changed state for the debounce duration.
If you type "2" from the "Sampling Setup" menu shown on the previous page
(Latch Polarity), the PDI will respond with the following:
SET LATCH POLARITY
Latch Polarity..................HI TO LO
Low to Hi Transitions only......1
Hi to Low Transitions only......2
Exit............................X
Enter Selection:
Enter the desired Latch Polarity. The Latch Polarity is used to latch initial events
for individual inputs based on a positive going (LO to HI) or negative going (HI to
LO) input.
5.1.4 REPORTING SETUP
By responding to the Enter Selection: message at the end of the Configuration
Main Menu (see Section 5.1.1) with "3" (Reporting Setup), you may program how
the PDI reports event samples to the host device. The items you may program are
Reporting Method, Report Start Time, Report Interval, Host Address, Data
Format, Time Tag, and Terminating Character(s). The operational functionality of
these items is discussed in Section 4.2.2. The PDI will respond with the Reporting
Setup menu as follows:
REPORTING SETUP
Reporting Method...................1
Report Start Time..................2
Report Interval....................3
Host Address.......................4
Time Tag...........................5
Terminating Character(s)...........6
Exit...............................X
Enter Selection: