Bay Technical Associates V79 PDI-1 - Manual (Page 36)

32
5.3 FRONT PANEL CONFIGURATION
The LCD display and associated front panel controls can provide the configuration
status of the PDI. All the parameters shown in the LCD status message are fully
described in Section 5.1.
When the M8/M16 DAC has completed its power-up self-test, the following menu
will be displayed on the LCD:
Bay Technical Assoc
Select Module
00
NOTE: The following LCD screens are examples and will vary depending upon
current configuration status.
To review the configuration status of the PDI installed as Module XX (XX = 02 to
16), use the
>
or
?
keys to highlight "Module XX" from the M Series main menu
screen and press the SELECT key. The LCD will respond with a menu similar to
the following for the PDI-1:
V78 PDI-1 MODULE XX
Display Status
Exit Module Menus
Select "Display Status" the LCD will respond with:
Debounce Delay 10
Latch Polarity HI/LO
Report Method COMMAND
76 -PAGE SELECT-EXIT
Pressing the
>
or
?
keys scrolls through the following entries:
Report Interval HH:MM
Host Address 1:1,1
Time Tagging ENABLE
Term Characters 0D0A
Dyna Cfg Cmd ENABLE
To exit the configuration status mode, press the SELECT key at any time. You
are returned to the PDI's LCD main menu. Next, press either arrow key until the
cursor is located on the "Exit Module Menus." Pressing the SELECT button
returns you to the main M Series LCD menu.