Bay Technical Associates V79 PDI-1 - Manual (Page 33)

29
Dynamic configuration mode allows the PDI to be programmed by downloading
dynamic (on-the-fly) commands. See Section 5.2 for the procedure to program
the PDI via dynamic configuration and a description of the available configuration
commands.
5.1.6 EXIT
By responding to the Enter Selection: message at the end of the Configuration
Main Menu (see Section 5.1.1) with "X" (Exit), the PDI will exit the menu-driven
configuration mode. If changes are made to any configuration parameter, the PDI
will respond with:
Save Changes as Defaults? (Y/N)
If you reply in the affirmative (Y), the settings are saved as the permanent power-
up defaults. That is, if the M16/M8 loses power for any reason, the settings saved
as defaults become the power-up settings. If you reply in the negative (N), your
selections are saved as current (temporary) operating settings, but are lost upon
power-down. The most recent menu selections saved as Defaults are restored as
the current operating parameters when power is re-applied. If you respond with
"Y", the PDI will respond with:
Saving Configuration as Defaults...
Configuration complete