BNC 7000 Series User Manual - Manual (Page 31)

31
3.4.4.6 Delete traces
Selected can be removed from the trace list by clicking on “Del” button.
3.4.4.7 Edit button
Selected traces can be edited with “Edit” button that opens a window as show below.
In this window, first choose to which traces the changes shall be applied: selected traces only, all
stored traces, or all newly measured traces.
The following functions can be applied:
1. Completely remove or show detected spurious signals that are above a user set threshold.
2. Apply video averaging (smoothing) to the trace with user set aperture.
3. Shift trace by a user specified number of decibels (up or down).
Changes are immediately applied to the traces. The “Apply” button just confirms and closes the
window.
3.4.4.8 Settings button
With the “Settings” button, the plot configuration window is opened as shown below. In this window,
the following general plot settings can be changed:
1. Assign a Title to the plot
2. Visualize Legend, Spur List, DUT Information, Marker List, or Jitter Data window
3. Change plot window background and grid color
4. Modify X and Y scales, labels, and units.
5. Modify Spur unit
Changes are immediately applied to the traces. The “Reset” button allows resetting to default values.
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com