SkyTrak 10054 Operation Manual - Manual (Page 121)

Ge nera lM ain ten anc e
119
Model 10054 Rev 3/02
4.If repl acin gs afety eleme nta tth isti me( Figur e75) ,r emov ew ing nut
an dc aref ully slid es afety elem entout .A lw ays dis ca rd th isel ement
an dr epla cewith an ewe lem entand secu re with wing nut.
5.In stall thene wpr imar yele ment and sec ure with wing nut.
6.P ositi onca niste rc over in plac ea ndsec ure withc over wing nut.
Figure 75
C.Ai rI ntak eS yste m-In spec tion
Insp ect the intak epip ingf orcr ac ke dh oses ,l oose clam psor punc tures
whic hc anal low dir to rdeb ris to enter thec omb ust ionch amber .If dir tor
debr is are allo wed to enter thec ombus tion cha mber, the yc anse ver ely
dama get hee ngine .I fnec ess ary, tighte nor rep lace parts topr eve ntai r
inta ke sy stem leak age.
OF0120
Wing Nut
Safety Element
1000
OT0880 OH26 90
General Maintenance
119 Model 10054 Rev 3/02
4. If replacing safety element at this time (Figure 75), remove wing nut
and carefully slide safety element out. Always discard this element
and replace with a new element and secure with wing nut.
5. Install the new primary element and secure with wing nut.
6. Position canister cover in place and secure with cover wing nut.
Figure 75
C. Air Intake System-Inspection
Inspect the intake piping for cracked hoses, loose clamps or punctures
which can allow dirt or debris to enter the combustion chamber. If dirt or
debris are allowed to enter the combustion chamber, they can severely
damage the engine. If necessary, tighten or replace parts to prevent air
intake system leakage.
OF0120
Wing Nut
Safety Element
1000
OT0880 OH2690