SkyTrak 10054 Operation Manual - Manual (Page 147)

Ge nera lM ain ten anc e
145
Model 10054 Rev 3/02
Figu re 10 0
B.Rear Axle
1.W ork in gt hroug ht he le ve lp lu ghol e( Fig ure 99), care fully use a
sc re wdr iv er tos prea dthe brak edi sks apart .
IMPOR T ANT! DONO Tdam agethe surf aces of thebr ake disk sw hen
spre adin gt heb ra ke dis ks.
2.Us ing afee lerg auge, chec kt hegap (F igu re 100) between the
brak ed isks .I ft heg ap is gre ater th an .1 67" (4, 25 mm ), re pla ce th e
brak ed isks .
NOTE:I ft he bra kedi sks are wo rnbe yon d. 167 "( 4,2 5m m), th ebr ake dis k
must be re pla ced onb oth side so ft he axle att he sam et im e.
3.Re peat step 1an ds tep2 for the other side of theax le.
4.Co ntinue with step 6of “B .A xle Oil Chang e” onpag e14 1.
Ch eckG ap
MT2840
Bra keD isks
General Maintenance
145 Model 10054 Rev 3/02
Figure 100
B. Rear Axle
1. Working through the level plug hole (Figure 99), carefully use a
screwdriver to spread the brake disks apart.
IMPORTANT! DO NOT damage the surfaces of the brake disks when
spreading the brake disks.
2. Using a feeler gauge, check the gap (Figure 100) between the
brake disks. If the gap is greater than .167" (4,25 mm), replace the
brake disks.
NOTE: If the brake disks are worn beyond .167" (4,25 mm), the brake disk
must be replaced on both sides of the axle at the same time.
3. Repeat step 1 and step 2 for the other side of the axle.
4. Continue with step 6 of “B. Axle Oil Change” on page 141.
Check Gap
MT2840
Brake Disks