SkyTrak 10054 Operation Manual - Manual (Page 50)

48 Model 10054 Rev 3/02
Operation
Worklight Switch (with Optional Road Lights)
(Figure 29)
This rocker switch activates the worklight system. The switch is located in
the upper switch bank on the right side dash panel. This system will only
operate when the ignition switch is in the RUN position. See “Parking Lights,
Headlights & High/Low Beam Switch” on page 50 for operation of the road
lights.
• Push the top of the switch IN to
DEACTIVATE the entire the worklight
system.
• To ACTIVATE the boom worklight
position the rocker switch to the center
position.
• Push the bottom of the switch IN to
ACTIVATE the boom worklight and
rear worklights.
Figure 29
OH2620
OH2591
OH2611
OH2601
OH1862
Road Light/Worklight Switch
48
Model 10054 Rev 3/02
Operati on
Worklight Switch (withOptional RoadLi ghts)
(F igur e2 9)
Th is roc ker sw itc hac tiv ate st hew ork ligh ts ys tem .T hes wit chis loca tedin
the up pers witc hb ankon ther ight sid eda shpan el. Thi ss ys tem will on ly
oper ate when thei gnitio ns witch isi nth eR UNpos ition .See “P arki ngL ig hts,
Headl ights &Hig h/Low Be am Swi tch” onp age50 for oper ation ofthe ro ad
ligh ts .
• Pus hth et op ofthe swit chIN to
DEA CT IV A T Eth een tir et hew ork light
system .
• T o AC TIV A T Ethe boom wor klight
po siti onth er ock er swi tch tot hec en ter
pos iti on.
• Pu sh the bo ttomof thes witch INto
AC TIV A T Ethe boom wo rk ligh tan d
re ar wo rk light s.
Figure 29
OH2 620
OH259 1
OH2611
OH2601
OH1862
Road Light/W orklight Switc h