Bosch 500 - Manual (Page 33)

MIC Series 500 Camera Navigating the Menus | en 33
Bosch Security Systems, Inc. User’s Manual F.01U.173.601 | 2.0 | 2010.11
5.7.1 Factory Defaults
Restores the camera unit to the Factory Default settings. See Section 5.14.1 Factory Defaults,
page 49.
5.7.2 Re-map Pelco Aux (Pelco D and P Protocols only)
The Pelco protocols (D and P) support 8 different auxiliaries, but do not define what function
each should perform. This feature enables the 8 available auxiliaries to be set to any of the 8
available functions (Auto Focus, Digital Zoom, Auto Iris, Wiper, Washer, OSD and Backlight).
By default, the auxiliaries are mapped as follows:
CLEAR SOFT
STOPS
Clears any Soft stops that have been applied. RIGHT TO
CLEAR
N/A
MANUAL
CONTROL
Gives the user 10 seconds of manual control of the camera to allow the operator to move the
camera to the desired position before the menu returns to its previous state.
WASH WIPE
POSITION
Sets the wash position by pointing the camera at the washer nozzle
and pressing right to set.
RIGHT TO SET
POS
current
camera
position
SET ZERO
POS
Sets the zero degree (North) position when using the compass
direction captions. For example, point the camera North, Set Zero Pos,
resulting in the caption correctly displaying the compass heading.
RIGHT TO SET
POS
N/A
UPPER LEFT
AND LOWER
RIGHT SOFT
STOP
Soft Stops enable the user to set up an imaginary box within which the
camera can move. There is only one zone available which is defined by
first setting the Top Left and then the Bottom Right of the zone. Once
activated the MIC cannot be moved beyond the area set.
RIGHT TO SET
POS
Cleared
LEFT AND
RIGHT AUTO
PAN LIMITS
These 2 settings define the limits within which the camera will pan at
the “Auto Pan Speed” when the “Auto Pan” feature is activated.
RIGHT TO SET
POS
Cleared
MAP AUX TO
PRESET
This option opens a submenu that allows certain features of the
camera which would normally be controlled through Aux commands to
be mapped to Go To Preset commands. The features available for this
are Wiper, Washer, Digital Zoom, Auto Iris, Auto Focus, and Auto Pan.
For each function there are 3 options: Control, On Preset, and Off
Preset. The control field denotes if the function is activated by the
normal aux command or through a preset. The other 2 options set the
preset number to activate or deactivate each function. This provides
the ability to run all of the camera’s standard auxiliaries from a wider
range of control systems with varying direct aux support.
Note: If the control field of any of the functions is set to Go To Preset,
then the feature will not work using a standard button from a normal
controller. Similarly, if mapped to an Aux command, the preset values
indicated will have no effect.
WIPER,
WASHER,
DIGITAL
ZOOM,
AUTO IRIS,
AUTO FOCUS,
AUTO PAN
N/A
FIND END
STOPS
Rotates the tilt axis first down then up to its mechanical limit stops. It
then stores a “soft” limit a few units back from these for normal use.
Note: manual control is not available during this process.
RIGHT TO
START
N/A
RESET TO
DEFAULTS
Resets to the default settings for all OSD menus. CONFIRM
RESET, NO
N/A
Menu Item Description Options Default