Baby Trend Flex-Loc Infnat Car Seat CSO190AD809 - Manual (Page 39)

7.0
INSTALLATION
39
5. Check that the vehicle seat back is locked in the upright
position and will not fold forward onto the Safety Seat.
(Fig. 39-1)
7.2 Installation of the Safety Seat / Vehicle
Belt Installation of Base:
1. Remove the Safety Seat from the base
by squeezing the base release handle
located under the center of the foot end of
the Safety Seat and lifting upward on the
Safety Seat (See Fig. 25-1). Store both
LATCH connectors as shown in Fig.
44-1.
2. If you are using the Base with the Safety
Seat, place the Base in the rear-facing
position in a forward facing vehicle seat
as shown in Fig. 39-2. If you are using
the Safety Seat without the Base, place
the Safety Seat in a rear-facing position
in a forward facing vehicle seat as
shown in Fig. 40-1. The Child must face
the rear of the vehicle and Safety Seat
must be placed in a vehicle seat that
faces forward.
3. See Fig. 39-2 for the proper threading of
the vehicle belt through the Base and Fig.
40-1 for the proper threading of the belt
Fig. 39-1
Folding seat must
be locked
Fig. 39-2
Lap/Shoulder Belt
Lap Belt only