Baby Trend Flex-Loc Infnat Car Seat CSO190AD809 - Manual (Page 47)

47
7.0
INSTALLATION
1. Safety Seat with Base: Make sure the
vehicle is parked on level ground. Lock
the Safety Seat onto the Base and
check that the Safety Seat is level side
to side on the vehicle seat. (Fig. 47-1)
Check the Seat Angle Indicator that
matches the weight of your child.
• If the Seat Angle Indicator shows NO
red, the seat is installed at the proper
level of recline.
• If the Seat Angle Indicator shows
ANY red, the Safety Seat is either
too upright or too reclined . If the
seat is too upright, extend the foot
one position at a time just until no
red shows. To extend the foot of the
base, pull downward on the hand hold
as shown in Fig. 47-2 while holding
onto the base. To retract the foot,
press inward on the lock button as
shown in Fig. 47-3 and push upward
on the foot. Be careful not to pinch
your finger as the foot retracts.
Check the level indicator to see if the
seat is now level.
• If seat angle adjuster feature does
not adjust enough to provide the
Fig. 47-1
Fig. 47-2
Fig. 47-3
Foot Adjustment
Lock Button